Bio-Cryl 652

Single component, water based acrylic coating designed for application on new or existing roof structures. Provides excellent exterior durability and flexibility for adverse environmental conditions.
PREMIUM WHITE ELASTOMERIC ROOF COATING

BIO-CRYL® 652 is a 100% acrylic, water reducible, corrosion resistant coating for industrial use. Designed for both new construction and maintenance use, it provides a uniquely adhesive and flexible reflective surface when used directly over metal, urethane, concrete, smooth BUR, EPDM, Hypalon and other approved roof surfaces.

BIO-CRYL® 652 Properties:

  • Outstanding adhesion
  • Water clean up
  • Permanent Flexibility
  • Excellent exterior durability
  • Simple one-component application
PROTECTIVE COATING:
Over all types of new or existing roofs.

UV RESISTANT COATING

VEHICLE TYPE : 100% acrylic resin

PIGMENTATION : Color/Inert

COLORS : White

FINISH : Semi-Gloss

THINNER : Not normally required – water if necessary

CLEANER : Soapy Water

MIXING RATIO : NA – single component

INDUCTION TIME : Not required

POT LIFE : NA – single component

FLASH POINT : Over 200° F

SOLIDS BY VOLUME : 52%

SPREADING RATE/GAL : 100 sq.ft./gallon at 8.4 mils

DRY TIME, (Between Coats) : 24 hours at 77° F

APPLICATION METHOD : Brush, roller, airless or conventional spray

STORAGE CONDITIONS :  Normal, Avoid Freezing

VOC : <50 g/L;

SURFACE PREPARATION:

Surface must be clean and dry, and in sound condition. Remove all oil, dust, dirt, loose rust, and other foreign matter to ensure adequate adhesion. Do not use hydrocarbon solvents such as regular paint thinner for cleaning since these may leave an incompatible residue which will reduce adhesion. Power washing to remove dirt and excessive chalking is preferred.

MIXING PROCEDURE:

Mix well in can or pail to ensure homogeneity before application.

APPLICATION:

1) Use a brush or roller to apply from a tray for a coverage rate of about 100 sq.ft. per gallon.

Nylon/Polyester brushes
3/4” woven solvent resistant core
No reduction – apply straight from can

2) Apply by airless spray using the following equipment setup:

Spray Unit: All Graco commercial units or similar equipment
Mix ratio: single component
Fluid pressure: 2,800 psi
Fluid temp: ambient
Filters: 60 mesh
Tip: .033″ orifice – no diffuser pin – reversible
Reduction: Add up to 12.5% water as necessary

Do not apply at temperatures below 50°F or when rain is forecast. High humidity will extend dry time.

CURING BEFORE SERVICE:

BIO-CRYL® 652 will be hard and fully functional within 24 hours. However, it will be about 30 days at 77° F before it is fully cured.


WE URGE YOU TO READ THE MATERIAL SAFETY DATA SHEET (MSDS) BEFORE USING AND TO CALL THIN FILM TECHNOLOGY, INC., AS NECESSARY FOR ADVICE OR INFORMATION BEFORE ANY ACTUAL OR CONTEMPLATED APPLICATION.

SAFETY: This is a hazardous material if misused. Read and understand the Material Safety Data Sheet (MSDS) before use.

WARRANTY DISCLAIMER: The technical data given herein has been compiled for your help and guidance and is based upon our experience and knowledge. However, as we have no control over the use to which this information is put, no warranty, express or implied, is intended or given. We assume no responsibility whatsoever for coverage, performance or damages, including injuries resulting from use of this information or of products recommended herein.

DOWNLOAD BIO-CRYL® 652 PRODUCT DATA SHEET