Bio-Cryl 651

Single component, water based acrylic coating designed for application over fresh epoxy coatings or composites. Unlike polyurethane it provides excellent UV resistance with easy recoating after years of service.
BIO-CRYL™ 651 is a 100% acrylic, water reducible, corrosion resistant coating for industrial use. Designed for both new construction and maintenance use, it can be used directly over prepared metallic or coated industrial surfaces.

BIO-CRYL™ 651 Properties:

  • Chemical Resistant
  • Corrosion Resistant
  • Fast Dry
  • Low Odor, Low VOC
  • Flash rust/Early rust resistant
  • Interior or Exterior use
  • Single component
  • Outstanding ease of application
  • Water clean up
PROTECTIVE COATING:
Over steel, galvanizing, wood, aluminum, concrete, other coatings

UV RESISTANT COATING

USDA FACILITIES & HIGH PERFORMANCE ARCHITECTURAL APPLICATIONS

VEHICLE TYPE : 100% acrylic resin

PIGMENTATION : Color/Inert

COLORS : Wide Range including Safety Colors

FINISH : Semi-Gloss

THINNER : Not normally required – water if necessary

CLEANER : Water

MIXING RATIO : NA – single component

INDUCTION TIME : Not required

POT LIFE : NA – single component

FLASH POINT : Over 200° F

SOLIDS BY VOLUME : 38%

SPREADING RATE/GAL : 244 sq.ft./gal @ 2.5 mils dft

DRY TIME, (Dust free) : 1 hour at 77° F

APPLICATION METHOD : Brush, roller, airless or conventional spray

STORAGE CONDITIONS : Normal, Avoid Freezing

VOC : <250 g/L; 2.08 lb/gal

SURFACE PREPARATION:

Surface must be clean and dry, and in sound condition. Remove all oil, dust, dirt, loose rust, and other foreign matter to ensure adequate adhesion. Do not use hydrocarbon solvents such as regular paint thinner for cleaning since these may leave an incompatible residue which will reduce adhesion.

MIXING PROCEDURE:

Mix well in can or pail to ensure homogeneity before application.

APPLICATION:

1) Use a brush or roller to apply from a tray for a coverage rate of about 250 sq.ft. per gallon.

Nylon/Polyester brushes
3/8” woven solvent resistant core
No reduction – apply straight from can

2) Apply by airless spray using the following equipment setup:

Spray Unit: All Graco commercial units or similar equipment
Mix ratio: single component
Fluid pressure: 1,500 psi
Fluid temp: ambient
Filters: 60 mesh
Tip size: .017″ -.021″ orifice
Reduction: Add up to 12.5% water as necessary

CURING BEFORE SERVICE:

BIO-CRYL™ 651 will be hard and fully functional within 24 hours. However, it will be about 30 days at 77° F before it is fully cured.


WE URGE YOU TO READ THE MATERIAL SAFETY DATA SHEET (MSDS) BEFORE USING AND TO CALL THIN FILM TECHNOLOGY, INC., AS NECESSARY FOR ADVICE OR INFORMATION BEFORE ANY ACTUAL OR CONTEMPLATED APPLICATION.

SAFETY: This is a hazardous material if misused. Read and understand the Material Safety Data Sheet (MSDS) before use.

WARRANTY DISCLAIMER: The technical data given herein has been compiled for your help and guidance and is based upon our experience and knowledge. However, as we have no control over the use to which this information is put, no warranty, express or implied, is intended or given. We assume no responsibility whatsoever for coverage, performance or damages, including injuries resulting from use of this information or of products recommended herein.

DOWNLOAD BIO-CRYL™ 651 PRODUCT DATA SHEET